EZdc DC Converter
- 300, 450 and 900 watt versions
- 36, 48 or 80V input, 12 or 24V output
- Compact form factor
- IP67 rated
Components
CANTilt Module
- Dual axis tilt measurement
- 20 degrees
EZfit
- Single axis angle sensor
- 60 degrees
Terminal Block Module (TBM)
- Reduces wiring
- Simplifies power connection installation
- Built-in current sensing allows main controller to test and
detect short circuits and open coils.
Diagnostic Center Display
- 2 line 16 character backlit display
- Simplifies setup and testing
- Optional customer specified front panel
CANOpen Joystick
- Multi-axis joystick
- Configurable with custom CAN or J1939
- Supports additional external I/O
Pressure Transducer
- 1250, 2000 and 3000 psi versions
- IP69K rated
- Fully protected (reverse supply, short circuit, etc)
Load Cell Interface Module
- CANbus
- Meets Category 3
GP102 Overload System
- Platform pressure based overload system
- Integral tilt sensor
- EN280 certified, provides failsafe cutout signal
- Configurable lamp and alarm outputs
GP106 Outrigger System
- Outrigger auto-leveling system
- Controls four (4) outrigger extend valves
- Integrated tilt sensor
- Provides PWM & protected high side outputs
GP107 Overload System
- Uses two or four strain gauge/load cell transducers to detect load
- Prevents vehicle movement when overload detected
- EN280 certified, provides failsafe cutout signal
- Configurable lamp and alarm outputs
- RS232 connection to EZcal hand held tool